According to the on-line manual: "By default, the Key Switches are positioned starting from C1 (MIDI note 24)where C3 = Middle C (MIDI note 60)" .... "C# = Fall Down. Perform an immediate Fall Down starting from the currently playing note (where the pitch and volume drop rapidly):
○ Velocity controls Fall Down speed.
● D = Doit. Perform an immediate Doit starting from the currently played note (where
the pitch rises rapidly and the volume decays):"
After not having any luck with getting a doit or fall I went into Midi Mapping and found the KS octave was set to off, and there were no parameters set under External Controller Mapping for Doit or Fall.
Is this correct? If not what should be the settings? Do you need a velocity sensitive keyboard to use this function?
I tried to control doit and fall with a IK Blueboard after using midi learn but only got a small amt of doit and fall. The Blueboard buttons toggles on or off so I will try hooking up a pedal up next.
According to the on-line manual: "By default, the Key Switches are positioned starting from C1 (MIDI note 24)where C3 = Middle C (MIDI note 60)" .... "C# = Fall Down. Perform an immediate Fall Down starting from the currently playing note (where the pitch and volume drop rapidly):
○ Velocity controls Fall Down speed.
● D = Doit. Perform an immediate Doit starting from the currently played note (where
the pitch rises rapidly and the volume decays):"
After not having any luck with getting a doit or fall I went into Midi Mapping and found the KS octave was set to off, and there were no parameters set under External Controller Mapping for Doit or Fall.
Is this correct? If not what should be the settings? Do you need a velocity sensitive keyboard to use this function?
I tried to control doit and fall with a IK Blueboard after using midi learn but only got a small amt of doit and fall. The Blueboard buttons toggles on or off so I will try hooking up a pedal up next.